The Tape Application Technique
It is necessary that you attach your full lace wig in such a approach that it appears fully wave natural. It may be performed however it might take somewhat follow. There clip in closure are some tricks to be learned though however once you study them, correct utility of your full lace wig is a cinch.
Pre-Lower Wig Tape
Most wig utility tapes come in precut strips to make utilizing them extra handy to make use of. Nevertheless; if the tape that you’re utilizing isn’t precut, you’re going to have to chop some strips to fit your scalp. It’s pre-bonded tape that’s sticky on both sides, so it would adhere to both your head and the wig.
Cowl Your Scalp Evenly With Wig tape
Reduce an excellent variety of strips and stick them to your scalp above your pure hairline in such a manner that the whole perimeter of your scalp is covered evenly. After this is done then you are ready to begin attaching your full lace wig.
Sticking the Again Of Your Full Lace Wig Down
Apply your wig from the entrance to the again using hand stress to insure that it’s stuck down properly. One factor to recollect as you get to the “back” or “nape area” is to crunch your head down as far as you’ll be able to, so your chin buts into your chest as you apply the wig.
An Vital Step To remember To Do
This is to insure that the wig is in place in such a way that ought to you must look down at some point while you’re sporting it, it will not come undone or look unnatural in any manner due to the stress in the back that will likely be created by having to look down.
Attempt Not to Sweat Rather a lot
Finally, you will want to make use of a tight head band around the perimeter of your head after the wig has been fully hooked up. It must be worn for 5 minutes or so to insure that the complete lace wig is totally bonded to your scalp. One other thing to remember, is that you should keep away from any activities that can result in heavy perspiration, as this could cause full lace wigs to come back unfastened.